How to Replace Your Food Showcase Water Filter

food showcase water filter replacement

Table of Contents

If you own a Food Showcase refrigerator, then you know how important it is to keep your water filter in good working order. Not only does it ensure that your water tastes clean and fresh, but it helps protect the integrity of your refrigerator.

Fortunately, replacing a Food Showcase water filter is an easy process that can be done in just a few steps.

Step 1: Locate the Filter Cover.

The first step is to locate the filter cover on the inside wall of your refrigerator. Typically, this is located at the top-right corner of the fridge next to the ice maker unit. Once you have found it, pull down on the cover to expose the filter housing.

Step 2: Remove and Replace Old Filter.

To remove and replace an old filter, grab onto its handle and give it a quarter turn counterclockwise until it unlocks from its housing. Pull out the old filter and discard properly.

Then insert your new filter into its housing, give it another quarter turn clockwise until it locks into place, and close the filter cover.

Step 3: Reset Your Fridge’s Water System.

As soon as you have replaced your new filter, reset your refrigerator’s water system by pressing and holding down both buttons on either side of the display panel for three seconds until you hear a beep indicating that reset has been successful. You may now begin using your refrigerator’s water dispenser as normal!


Replacing a Food Showcase Water Filter doesn’t have to be complicated or difficult; with these simple steps you can easily replace an old filter with a new one in no time at all!

By taking care of this simple maintenance task regularly we recommend every 6 months you’ll help keep your fridge running smoothly for years to come without any disruption or inconvenience!

So make sure you don’t forget about this important part of your home maintenance routine today!

Leave a Reply

Your email address will not be published. Required fields are marked *